After leveling the door, turn the keeper nut clockwise to tighten it.
Lg refrigerator door mullion adjustment.
After leveling the door, turn the keeper nut clockwise to tighten it.
Due to the wide variety of french door models, we recommend that you refer to the owner's manual for specific model instructions.
If your refrigerator seems unsteady or you want the doors to close easier, adjust the refrigerator tilt using these instructions.
Using the recommended wrench, turn the adjustment hinge pin clockwise or counterclockwise to level the refrigerator door.
Adjust the leveling screws to the right or counterclockwise to lower the refrigerator a little.
It appears that the striker plate that engages the tab on the top of the mullion has been installed 1/2 too far to the right so that it does not push the mullion back far enough to make let the spring flip it back when you open the left hand door.
When closing the left door, the mullion is supposed to catch the door older at the top of center mullion to pull the center flap out.
Click to see full answer
Hold the flipper mullion near the door and connect the flipper mullion wire harness.
Using the recommended wrench, turn the adjustment hinge pin clockwise or counterclockwise to level the refrigerator door.
Your lg refrigerator has two front leveling screws, one on the right and one on the left.
A) pull old gasket gently by hand out of fridge b) line up gasket with inset ridge around.
If the door of an lg refrigerator closes too fast, it means the unit is tilted too far back.
Attach the flipper mullion to the top and bottom mounting brackets.
If it still slams too fast, check the items you placed in the door.
Align the center bracket mounting holes and install the mounting screws.
There does not appaer to be any adjustment to move the striker plate more to.
A) unscrew 2 screws in middle section of old mullion b) unhook electrical connection behind mullion c) with tow hands, pull the entire old mullion straight downward to unhinge the mullion from door then remove old mullion d) install new mullion in reverse order 2) install gasket: